Ellsworth

Ship stats

Depth: 29 feet

Coordinates: 43° 54.739'N/ 76° 18.149'W

Vessel Type: Wooden steam barge (built as schooner-rigged canal boat)

Length: 117 feet

Breadth: 17.6 feet

Gross Tonnage: 135.67

Cargo: Passengers

Built: 1867 by C.T. Lamont at Geneva, New York

Port of Registry: Oswego, New York

Owner at Loss: Abner C. Mattoon, Oswego, New York

Date Lost: July 10, 1877

Cause of Loss: Burned

Loss of Life: None

Historical Background

The wooden steam barge Ellsworth was built in 1869 by C. T. Lamont at Geneva, New York as a schooner-rigged sailing canal boat. As-built, Ellsworth was 92 feet long, 17.5 feet in breadth and had a 8.6-foot depth of hold, measuring 113.49 gross tons.

Ellsworth was initially employed on the Oswego and Erie Canals before being purchased by Abner C. Mattoon of Oswego, New York in 1870. In 1870–1871, Mattoon rebuilt Ellsworth, converting it to a steambarge, reportedly reusing the engine of the tugboat George S. Dodge, which had been destroyed by a boiler explosion at Oswego on September 29, 1870.

Mattoon initially employed Ellsworth in an unsuccessful venture pursuing timbering land grants along the Peace River in southwest Florida between 1871 and 1872. Later in 1872, Ellsworth returned to the Great Lakes. It was again rebuilt the following year, increasing its length to 117 feet and its gross tonnage to 135.67 tons with the intention of employing it in the Great Lakes grain trade.

On July 10, 1877, Ellsworth departed Oswego Harbor to begin what Mattoon had planned to be a 10-day cruise among the islands at the northeastern end of Lake America and the head of the St. Lawrence River for himself and friends. That evening, Ellsworth anchored off the northeastern corner of Stony Island and the passengers had gone ashore to camp for the night. Only Mattoon and a steward remained aboard.

Around 10:00 that evening, fishermen from Stony Island sighted a fire aboard Ellsworth. Rowing out to Ellsworth, they were unable to climb aboard but succeeded in rousing Mattoon and the steward, and alerting them to the fire. Mattoon and the steward escaped in one of the boats as the fire spread rapidly, engulfing the ship. Ellsworth burned fiercely for several hours before burning down to its waterline and sinking.

In June 1879, Mattoon attempted to raise Ellsworth. He succeeded in raising Ellsworth’s boiler and engine which were installed in the steambarge Thomson Kingsford, which was then under construction. Attempts to salvage the ship’s hull were unsuccessful and only inflicted further damage.

Wreck Site

Today, Ellsworth rests in 29 feet of water, approximately 800 feet off the northeastern shore of Stony Island.

Ellsworth's hull is preserved below the waterline. Both the port and starboard sides have collapsed outward and lay alongside the hull on either side. Within the hull, a centerboard case lies on its side to starboard. This centerboard is likely a vestige of Ellsworth’s original construction as a sailing canal boat. The stern retains the highest profile on the wreck and retains its four-bladed propeller, the highlight of the site.